TAILGATE SAFETY TOPIC

The Humboldt Builders’ Exchange Safety and Insurance Committee provide the following safety topic as a service to its members. These instructions do not supersede local, state or federal regulations.

CART SAFETY

Provided by State Compensation Insurance Fund

Carts come in many sizes and styles and are used by workers in many industries. While carts and the reasons we use them vary, they have some common hazards and safety issues to consider.

Hazards associated with carts include using the wrong type for the job or the wrong size of cart for the worker (ergonomics). They can be hazardous when used in congested work areas and in areas of poor housekeeping. They can cause injury to the handler who’s had inadequate training. And, carts can cause the handler injury if the cart has not been properly maintained. All of these hazards require extra effort by the handler that may cause accidents that can result in sprains and strains, crush injuries, and fractures.

Make sure that the cart has the design and capacity for the job tasks. Some carts have open sides or spring loaded bottoms that assist the handler with loading and unloading. Carts should have enough room to store necessary supplies and equipment. Use carts for the intended purpose; reckless horseplay can lead to injuries. Unless the cart was designed to carry people, don’t allow passengers.

The floor or ground surface determines the best wheel type for the cart. Generally, larger and harder wheels are easier and require less force to push. Steel wheels are the easiest, followed by hard rubber, and plastic; soft rubber wheels are the hardest to push. For tight spaces and crowded work conditions, four swivel wheels or casters add maneuverability. For pushing long distances, two swivel wheels and two straight wheels ease movement.

Carts need a wheel-locking mechanism to park them. Take care where you park your cart; don’t block walkways, exits or doorways. A braking system adds additional control on slopes and ramps.

Handles should be located at the rear of the cart and at the proper height for pushing. It is easier on your back to push than to pull. Lean in the direction in which you are going and use your arms and legs (not your back) for leverage. If you must pull a cart, keep the cart at your side to avoid twisting your back.

Don’t overload the cart; you won’t see where you are going and it may overload the wheels. Don’t attempt to carry extra items while you are pushing the cart; when pushing, keep both hands on the cart handle. Inspect your cart each time you use it; it should be properly functioning and in good repair. Wheel bearings require periodic inspections and maintenance and damaged wheels should be replaced.

With proper training, use, and maintenance, carts can help you keep rollin’ on the job. 

The above evaluations and/or recommendations are for general guidance only and should not be relied upon for legal compliance purposes. They are based solely on the information provided to us and relate only to those conditions specifically discussed. We do not make any warranty, expressed or implied, that your workplace is safe or healthful or that it complies with all laws, regulations or standards © State Compensation Insurance Fund.

Company Name

________________________________________________________________________________________________

Supervisor’s Signature

________________________________________________________________________________________________

Meeting Attended By:

ý___________________________________  ý ___________________________________

ý ___________________________________  ý ___________________________________

ý ___________________________________  ý ___________________________________

State Compensation Insurance Fund

Powered by OnlineHostService